Heated Clothing

Choose based on where and how long you need heat, the product's required power system, and whether you want to be connected to the motorcycle. Portable battery systems can be independent of the bike, while motorcycle-powered systems can support a different riding setup. Confirm voltage, connectors, required controllers, battery compatibility, and runtime or electrical requirements from the exact product documentation.

Heated systems can include upper-body garments, vests, pants or liners, gloves or glove liners, socks, insoles, and related accessories. Availability and compatibility vary by system, so decide which areas you want to warm first and then verify that the specific pieces can operate together.

Match the exact system specifications rather than matching only by brand or connector appearance. Check voltage, connector type, controller requirements, battery or vehicle-power requirements, and any manufacturer compatibility statements for every component in the system.

Heated clothing should fit according to the manufacturer's sizing guidance and layer without restricting your riding position or the fit of outer protective gear. Many heated liners are intended to sit relatively close to the body through normal base layers, but the correct arrangement depends on the product. Check fit with the complete riding system you plan to wear.

Some heated products require or are designed to work with a controller, while others have built-in controls. Check the exact product instructions to see whether a controller is required, included, optional, single-zone, or multi-zone. Do not assume one controller works with every heated garment.

Many heated systems support multiple garments, but only when the pieces, connectors, controller, and power source are designed for that configuration. Verify the manufacturer's connection diagram and total electrical requirements before combining garments or adding splitters and adapters.

Check the heated gear's voltage and power requirements, the required fuse and harness arrangement, and whether the motorcycle has enough available electrical capacity for the planned system. Use the heated-gear manufacturer's instructions and the motorcycle manufacturer's electrical specifications when evaluating a setup, especially when combining several heated pieces.

It can if the heated gear and other accessories draw more power than the motorcycle's charging system produces. This is most likely at idle, at low RPM, or with several heated pieces on high at once. Compare the total draw of your heated gear with the spare output of your charging system, listed in the motorcycle's service information, and leave a margin for lights and other accessories.

Most heated liners and many heated gloves are not waterproof. Heated liners are designed to be worn under a waterproof jacket or rain gear. Check the product details for the specific item, and keep connectors dry and closed when they are not in use.

Runtime depends on the battery's capacity, the heat setting and the outside temperature. The high setting uses the most power and gives the shortest runtime. Check the runtime listed by the manufacturer for the specific product and battery, and carry a spare battery for long rides.

Disconnect the power and remove any batteries first. Then follow the manufacturer's care label, which differs by product:

• Spot clean with a damp cloth when possible.
• Hand wash only if the label allows it, using mild detergent.
• Air dry flat or hanging. Do not wring, tumble dry or iron heated garments unless the label says you can.
• Make sure connectors are completely dry before reconnecting.

Work through the power path from the source to the garment:

• Check that every connector is fully seated and free of corrosion.
• Confirm the battery is charged, or that the motorcycle harness is connected and the bike is running.
• Check the harness fuse and replace it with the size the manufacturer specifies.
• Test with a different controller or cable if you have one, to find the faulty part.
• Look for damaged wiring and stop using any part with exposed or melted wires.

If it still does not work, contact the manufacturer or contact us with your order number. Do not repair heated elements or wiring yourself unless the manufacturer supports it.

Warranty terms are set by each manufacturer and vary by brand and product type. Gloves, controllers and garments often carry different terms. Check the product page or the manufacturer's site for the exact coverage, keep your receipt, and register the product if the brand asks you to.